Phone (386) 734-5867  |  Fax (386) 734-8464  |

Jump Shack 3-Ring Inspection Instructions

Published by PLI on

The 3-Ring Riser has two important relationships, which must fall in a specified range. They are:

Small ring to middle ring. The small ring must align metal to metal with the middle ring while both are under maximum finger tension. There should be no circular space between the two rings.

Small Ring to Grommet. The small ring when doubled back up to the grommet and with maximum finger tension applied to the ring against it anchor should have a space.

Maximum and minimum relationships are shown.

Categories: Uncategorized

Leave a Reply

Your email address will not be published. Required fields are marked *